Home > LED Light Strip Connector > Snap SR

Snap SR

The SR series, LED strip snap connector is specially designed for connecting non-waterproof LED strip that is IP20 rated.
Onlumi has the widest range of LED strip snap connectors in the industry. In this series, there are 8mm 2 pins(single color),10mm 2 pins (single color),10mm 4 pins (RGB), 12mm 2 pins (single color) and 12mm 5pin (RGBW) in our company. From 30 LEDs to 120 LEDs, SR series will never disappoint you.

Snap SR Connector

Are you searching for the best solution for your LED light strip? We have got you covered. Onlumi provides the most efficient lighting solutions that save your effort and money all at the same. We are a leading supplier of LED lights, LED strip connectors, and many other lighting accessories. There is a wide selection of LED strip connectors including Snap SR connectors designed for non-waterproof strips. You can find 8mm, 10mm, and 12mm connectors having 2 pin, 3pin, 4pin, 5pin, and 6 pin poles. These connectors have nylon(PA66), PVC, and copper used in it and are available in white color.

Snap SR connector establishes a solderless connection between two strips without wire; one strip and power with 150mm 22AWG wire; two connectors with 150mm 22AWG wire. To connect a strip to power, peel the covering sheet attached on one side of the strip. Insert the uncovered strip into the connector till it reaches the center point. Place the strip light on the connector pins and clamp the connector cover. Your connection is complete. To connect a strip to a strip joint, peel covering sheets from both strips and insert them into the connector. Place the strip on the connector pins and close the cover.