Designed to connect RGBWW (RGB+CCT Dimmable ) 6 soldering pad led strip light.

Hippo-M LED Strip Connector 12mm 6 pin for rgbww IP20 non-waterproof
Hippo-M LED Strip Connector 12mm 6 pin for rgbww IP20 non-waterproof
1. For Non-waterproof
Model NO.TypesConnective Position
SEN12XB-6Strip to wire for IP20Between strip and wire
DJN12XB-6Strip to wire for IP65/54Between strip and wire
SEN12BB-6Strip to strip joint for IP20Between two strips, without wires
DJN12BB-6Strip to strip joint for IP65/54Between two strips, without wires
[contact-form-7 404 "Not Found"]
Close
Features
  • Allow user to attach 6 conductor flat wire according project requirement (Wire Color, Cross Section, length,etc)
  • Support big current
  • Good for high density light LED strip,don’t mask light of first LED.
  • Gripping LED strip very reliably
How to use

Strip end operation

hippo-m SEN12-5-1 Cut LED Strip along the cuttable mark
1-1: Cut LED Strip along the cuttable mark
1-2: Remove protective paper of adhesive tape
1-3: Insert LED strip to strip holder and press cap down
1-3: Insert LED strip to strip holder and press cap down
1-4: Finish connection to LED Strip

Wire end operation (if have)

2-1: Insert wire to wire holder of connector
2-2: Down close cap of connector
2-3: Ensure cap is locked by base of connector
2-4: Connection completed

Note: above operation is about non-waterproof version, waterproof types are such similar.

Workable LED Strip
  • LED Types: RGBWW / RGB+Dimmable
  • LED Quantity Supported: 30~90 LEDs/Meter

All LED strip listed above are RGBWW with 6 soldering pads on 12mm wide FPCB

Unit: mm